The Mutoh XP Sandblast 60 is a carbide vinyl cutter blade with a 60 degree cutting angle and a 0.75mm offset, made for Mutoh XP Series cutters. It is sold as a single blade or as a 5 pack.
When to use this blade
A 60 degree blade is for thick or sandblast stencil material and heavy reflective sheeting. The steeper angle puts more cutting edge into the material, so it gets through heavy stock at a sensible down force and keeps detail in it. For everyday calendered and cast sign vinyl, run the Mutoh XP Standard 45 instead; it is the normal choice for that work and lasts longer in it. Choose this blade when the material, not the artwork, is what makes the job hard.
Compatibility and specs
Fits Mutoh XP Series cutters. Angle 60 degrees, offset 0.75mm, carbide. Blade offset is the distance from the center of the blade shaft to the cutting tip, and the cutter or its software needs the same value entered so corners close cleanly. Set the offset to match this blade and check a small test cut before running a job. On sandblast stencil, set depth so the blade scores the liner without cutting through it, and test weed a small square before committing the sheet.
